Pitco-frialator Solstice supreme with Matchless Ignition (Built af Manuel d'utilisateur télécharger pdf (Page 15)

INSTALLATION

L20-378 rev.3 (01/13) 15

If your appliance is equipped with SPINFRESH

, the tank enclosure can interfere with the

performance of pre-existing fire safety systems. Modifications to the fire safety system should be

performed by a professional who is qualified in installing, designing and maintaining your fire safety

system prior to operating any SPINFRESH

appliance.

For Australia, the fryer must be installed in accordance with AS/NZS 5601, local authority and any other

relevant statutory regulations. Flexible hose (if used) must comply with AS/NZS 1869 Class B or D, be of

appropriate internal diameter, be kept as short as possible (not exceed 1.2 meters), must not be kinked

and not be in contact with a hot surface. A chain must be fitted to restrict the fryer movement to no more

than 80% of the hose length.

1.7. INSPECTION

Before you begin filling and adjusting the appliance, perform the following visual checks:

 After the appliance is in its permanent location, check the levelness. Any additional leveling that

is necessary can be performed as previously described.

 Ensure that the probe and high temperature limit is in place and secure. Check the high limit

bulb mounting screws to ensure that they are tight.

 Review the installation portion of this manual and ensure that all steps have been followed and

executed properly.

1) Probe

2) High Temperature Limit

WARNING

Ensure that your ventilation system does not cause a down draft at the appliance’s flue

opening. A down draft will not allow the appliance to exhaust properly and will cause

overheating, which may cause permanent damage. Damage caused by down drafts will not

be covered by the warranty. NEVER allow anything to obstruct the flow of combustibles or

ventilation exiting the appliance. NEVER place anything on top of the flue area, or block the

flue in any way. Never place a grease condensing drip pan over the flue opening.

WARNING

NEVER connect the ventilation blower or hood directly to the flue of this appliance. The

resulting increased flow of air through the combustion system will cause improper

operation, poor temperature recovery, poor ignition and could extinguish the pilot.

WARNING

Replacing or adding appliances under a pre-existing fire safety system may require

modifications to the system. ALWAYS contact a professional who is qualified in installing,

designing and maintaining your fire safety system to assure that any appliances located

under the fire safet

stem are adequatel

protected.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

Pitco-frialator Solstice supreme with Matchless Ignition (Built af Manuel d'utilisateur Page 15